From 328c11f24b5702d37b6a8e8d9836d964257e7d41 Mon Sep 17 00:00:00 2001 From: Andy Shevchenko Date: Wed, 18 Jul 2018 18:20:48 +0300 Subject: serial: 8250_exar: Remove useless has_slave member Exar UARTs by default supports only up to 8 channels, all above go as extension. Thus, there is no need to have an additional property to distinguish them from first ones. Signed-off-by: Andy Shevchenko Signed-off-by: Greg Kroah-Hartman --- drivers/tty/serial/8250/8250_exar.c | 7 ++----- 1 file changed, 2 insertions(+), 5 deletions(-) (limited to 'drivers/tty/serial/8250') diff --git a/drivers/tty/serial/8250/8250_exar.c b/drivers/tty/serial/8250/8250_exar.c index 102e059472ee..eafe70cff21a 100644 --- a/drivers/tty/serial/8250/8250_exar.c +++ b/drivers/tty/serial/8250/8250_exar.c @@ -113,7 +113,6 @@ struct exar8250_platform { struct exar8250_board { unsigned int num_ports; unsigned int reg_shift; - bool has_slave; int (*setup)(struct exar8250 *, struct pci_dev *, struct uart_8250_port *, int); void (*exit)(struct pci_dev *pcidev); @@ -394,10 +393,10 @@ pci_xr17v35x_setup(struct exar8250 *priv, struct pci_dev *pcidev, port->port.rs485_config = platform->rs485_config; /* - * Setup the uart clock for the devices on expansion slot to + * Setup the UART clock for the devices on expansion slot to * half the clock speed of the main chip (which is 125MHz) */ - if (board->has_slave && idx >= 8) + if (idx >= 8) port->port.uartclk /= 2; ret = default_setup(priv, pcidev, idx, offset, port); @@ -602,14 +601,12 @@ static const struct exar8250_board pbn_exar_XR17V35x = { static const struct exar8250_board pbn_exar_XR17V4358 = { .num_ports = 12, - .has_slave = true, .setup = pci_xr17v35x_setup, .exit = pci_xr17v35x_exit, }; static const struct exar8250_board pbn_exar_XR17V8358 = { .num_ports = 16, - .has_slave = true, .setup = pci_xr17v35x_setup, .exit = pci_xr17v35x_exit, }; -- cgit v1.2.3