From 65580b4321eb36f16ae8b5987bfa1bb948fc5112 Mon Sep 17 00:00:00 2001 From: Andiry Xu Date: Fri, 23 Sep 2011 14:19:52 -0700 Subject: xHCI: set USB2 hardware LPM If the device pass the USB2 software LPM and the host supports hardware LPM, enable hardware LPM for the device to let the host decide when to put the link into lower power state. If hardware LPM is enabled for a port and driver wants to put it into suspend, it must first disable hardware LPM, resume the port into U0, and then suspend the port. Signed-off-by: Andiry Xu Signed-off-by: Sarah Sharp Signed-off-by: Greg Kroah-Hartman --- drivers/usb/host/xhci-hub.c | 9 +++++++++ 1 file changed, 9 insertions(+) (limited to 'drivers/usb/host/xhci-hub.c') diff --git a/drivers/usb/host/xhci-hub.c b/drivers/usb/host/xhci-hub.c index d7be6d7324d3..9f844d45c667 100644 --- a/drivers/usb/host/xhci-hub.c +++ b/drivers/usb/host/xhci-hub.c @@ -574,10 +574,19 @@ int xhci_hub_control(struct usb_hcd *hcd, u16 typeReq, u16 wValue, switch (wValue) { case USB_PORT_FEAT_SUSPEND: temp = xhci_readl(xhci, port_array[wIndex]); + if ((temp & PORT_PLS_MASK) != XDEV_U0) { + /* Resume the port to U0 first */ + xhci_set_link_state(xhci, port_array, wIndex, + XDEV_U0); + spin_unlock_irqrestore(&xhci->lock, flags); + msleep(10); + spin_lock_irqsave(&xhci->lock, flags); + } /* In spec software should not attempt to suspend * a port unless the port reports that it is in the * enabled (PED = ‘1’,PLS < ‘3’) state. */ + temp = xhci_readl(xhci, port_array[wIndex]); if ((temp & PORT_PE) == 0 || (temp & PORT_RESET) || (temp & PORT_PLS_MASK) >= XDEV_U3) { xhci_warn(xhci, "USB core suspending device " -- cgit v1.2.3