From 107b7d6a7ad4927e1b217cf5667ac94bab021e42 Mon Sep 17 00:00:00 2001 From: Miquel Raynal Date: Mon, 19 Mar 2018 14:47:25 +0100 Subject: mtd: rawnand: avoid setting again the timings to mode 0 after a reset After a nand_reset_data_interface(), both the NAND chip and the NAND controller use timing mode 0. The previously defined data interface for this chip has been saved and is supposed to be restored after that. However, if the saved data interface also refers to timing mode 0, there is no need to re-apply them again. Also, as nand_setup_data_interface() uses ->set/get_features(), it could lead to issues when doing the reset at probe time as the parameter page is not available yet to know if these functions are supported or not. Signed-off-by: Miquel Raynal Signed-off-by: Boris Brezillon --- drivers/mtd/nand/raw/nand_base.c | 10 ++++++++++ 1 file changed, 10 insertions(+) (limited to 'drivers') diff --git a/drivers/mtd/nand/raw/nand_base.c b/drivers/mtd/nand/raw/nand_base.c index 837ea698af08..4099d8a1e25e 100644 --- a/drivers/mtd/nand/raw/nand_base.c +++ b/drivers/mtd/nand/raw/nand_base.c @@ -2816,6 +2816,16 @@ int nand_reset(struct nand_chip *chip, int chipnr) if (ret) return ret; + /* + * A nand_reset_data_interface() put both the NAND chip and the NAND + * controller in timings mode 0. If the default mode for this chip is + * also 0, no need to proceed to the change again. Plus, at probe time, + * nand_setup_data_interface() uses ->set/get_features() which would + * fail anyway as the parameter page is not available yet. + */ + if (!chip->onfi_timing_mode_default) + return 0; + chip->data_interface = saved_data_intf; ret = nand_setup_data_interface(chip, chipnr); if (ret) -- cgit v1.2.3