From d2e11da4b7fd0453e942f43e4196dc63b3dbd708 Mon Sep 17 00:00:00 2001 From: Pawel Baldysiak Date: Fri, 22 Feb 2019 13:30:27 +0100 Subject: mdmon: wait for previous mdmon to exit during takeover Since the patch c76242c5("mdmon: get safe mode delay file descriptor early"), safe_mode_dalay is set properly by initrd mdmon. But in some cases with filesystem traffic since the very start of the system, it might take a while to transit to clean state. Due to fact that new mdmon does not wait for the old one to exit - it might happen that the new one switches safe_mode_delay back to seconds, before old one exits. As the result two mdmons are running concurrently on same array. Wait for the old mdmon to exit by pinging it with SIGUSR1 signal, just in case it is sleeping. Signed-off-by: Pawel Baldysiak Signed-off-by: Jes Sorensen --- mdmon.c | 14 +++++++++++--- 1 file changed, 11 insertions(+), 3 deletions(-) (limited to 'mdmon.c') diff --git a/mdmon.c b/mdmon.c index 0955fcc5..ff985d29 100644 --- a/mdmon.c +++ b/mdmon.c @@ -171,6 +171,7 @@ static void try_kill_monitor(pid_t pid, char *devname, int sock) int fd; int n; long fl; + int rv; /* first rule of survival... don't off yourself */ if (pid == getpid()) @@ -201,9 +202,16 @@ static void try_kill_monitor(pid_t pid, char *devname, int sock) fl &= ~O_NONBLOCK; fcntl(sock, F_SETFL, fl); n = read(sock, buf, 100); - /* Ignore result, it is just the wait that - * matters - */ + + /* If there is I/O going on it might took some time to get to + * clean state. Wait for monitor to exit fully to avoid races. + * Ping it with SIGUSR1 in case that it is sleeping */ + for (n = 0; n < 25; n++) { + rv = kill(pid, SIGUSR1); + if (rv < 0) + break; + usleep(200000); + } } void remove_pidfile(char *devname) -- cgit v1.2.3