systemd sd_bus_message_get_monotonic_usec 3 sd_bus_message_get_monotonic_usec sd_bus_message_get_realtime_usec sd_bus_message_get_seqnum Retrieve the sender timestamps and sequence number of a message #include <systemd/sd-bus.h> int sd_bus_message_get_monotonic_usec sd_bus_message *message uint64_t *usec int sd_bus_message_get_realtime_usec sd_bus_message *message uint64_t *usec int sd_bus_message_get_seqnum sd_bus_message *message uint64_t *seqnum sd_bus_message_get_monotonic_usec() returns the monotonic timestamp of the time the message was sent. This value is in microseconds since the CLOCK_MONOTONIC epoch, see clock_gettime2 for details. Similarly, sd_bus_message_get_realtime_usec() returns the realtime (wallclock) timestamp of the time the message was sent. This value is in microseconds since Jan 1st, 1970, i.e. in the CLOCK_REALTIME clock. sd_bus_message_get_seqnum() returns the kernel-assigned sequence number of the message. The kernel assigns a global, monotonically increasing sequence number to all messages transmitted on the local system, at the time the message was sent. This sequence number is useful for determining message send order, even across different buses of the local system. The sequence number combined with the boot ID of the system (as returned by sd_id128_get_boot3) is a suitable globally unique identifier for bus messages. Note that the sending order and receiving order of messages might differ, in particular for broadcast messages. This means that the sequence number and the timestamps of messages a client reads are not necessarily monotonically increasing. These timestamps and the sequence number are attached to each message by the kernel and cannot be manipulated by the sender. Note that these timestamps are only available on some bus transports, and only after support for them has been negotiated with the sd_bus_negotiate_timestamp3 call. On success, these calls return 0 or a positive integer. On failure, these calls return a negative errno-style error code. On success, the timestamp or sequence number is returned in the specified 64-bit unsigned integer variable. Returned errors may indicate the following problems: -EINVAL A specified parameter is invalid. -ENODATA No timestamp or sequence number information is attached to the passed message. This error is returned if the underlying transport does not support timestamping or assigning of sequence numbers, or if this feature has not been negotiated with sd_bus_negotiate_timestamp3. sd_bus_message_get_monotonic_usec(), sd_bus_message_get_realtime_usec(), and sd_bus_message_get_seqnum() were added in version 209. systemd1, sd-bus3, sd_bus_new3, sd_bus_negotiate_timestamp3, clock_gettime2, sd_id128_get_boot3