ARM: OMAP2+: PRCM: split and relocate the PRM/CM globals setup

Split omap2_set_globals_prcm() into PRM, CM, and PRCM_MPU variants, since
these are all separate IP blocks.  This should make it easier to move the
PRM, CM, PRCM_MPU code into drivers/ in future patchsets.

At this point arch/arm/plat-omap/include/plat/prcm.h is empty; a
subsequent patch will remove it, and remove the #include from all the
files that #include it.

Signed-off-by: Paul Walmsley <paul@pwsan.com>
Tested-by: Vaibhav Hiremath <hvaibhav@ti.com>

1 files changed, 17 insertions, 0 deletions

diff --git a/arch/arm/mach-omap2/prcm_mpu44xx.c b/arch/arm/mach-omap2/prcm_mpu44xx.c
index 928dbd4f20ed..c30e44a7fab0 100644
--- a/arch/arm/mach-omap2/prcm_mpu44xx.c
+++ b/arch/arm/mach-omap2/prcm_mpu44xx.c
@@ -20,6 +20,12 @@
 #include "prcm_mpu44xx.h"
 #include "cm-regbits-44xx.h"
 
+/*
+ * prcm_mpu_base: the virtual address of the start of the PRCM_MPU IP
+ *   block registers
+ */
+void __iomem *prcm_mpu_base;
+
 /* PRCM_MPU low-level functions */
 
 u32 omap4_prcm_mpu_read_inst_reg(s16 inst, u16 reg)
@@ -43,3 +49,14 @@ u32 omap4_prcm_mpu_rmw_inst_reg_bits(u32 mask, u32 bits, s16 inst, s16 reg)
 
 	return v;
 }
+
+/**
+ * omap2_set_globals_prcm_mpu - set the MPU PRCM base address (for early use)
+ * @prcm_mpu: PRCM_MPU base virtual address
+ *
+ * XXX Will be replaced when the PRM/CM drivers are completed.
+ */
+void __init omap2_set_globals_prcm_mpu(void __iomem *prcm_mpu)
+{
+	prcm_mpu_base = prcm_mpu;
+}