diff options
Diffstat (limited to 'drivers/i2c/busses')
-rw-r--r-- | drivers/i2c/busses/i2c-aspeed.c | 2 | ||||
-rw-r--r-- | drivers/i2c/busses/i2c-i801.c | 26 | ||||
-rw-r--r-- | drivers/i2c/busses/i2c-mt65xx.c | 6 | ||||
-rw-r--r-- | drivers/i2c/busses/i2c-mxs.c | 10 | ||||
-rw-r--r-- | drivers/i2c/busses/i2c-npcm7xx.c | 8 |
5 files changed, 34 insertions, 18 deletions
diff --git a/drivers/i2c/busses/i2c-aspeed.c b/drivers/i2c/busses/i2c-aspeed.c index 31268074c422..724bf30600d6 100644 --- a/drivers/i2c/busses/i2c-aspeed.c +++ b/drivers/i2c/busses/i2c-aspeed.c @@ -69,6 +69,7 @@ * These share bit definitions, so use the same values for the enable & * status bits. */ +#define ASPEED_I2CD_INTR_RECV_MASK 0xf000ffff #define ASPEED_I2CD_INTR_SDA_DL_TIMEOUT BIT(14) #define ASPEED_I2CD_INTR_BUS_RECOVER_DONE BIT(13) #define ASPEED_I2CD_INTR_SLAVE_MATCH BIT(7) @@ -604,6 +605,7 @@ static irqreturn_t aspeed_i2c_bus_irq(int irq, void *dev_id) writel(irq_received & ~ASPEED_I2CD_INTR_RX_DONE, bus->base + ASPEED_I2C_INTR_STS_REG); readl(bus->base + ASPEED_I2C_INTR_STS_REG); + irq_received &= ASPEED_I2CD_INTR_RECV_MASK; irq_remaining = irq_received; #if IS_ENABLED(CONFIG_I2C_SLAVE) diff --git a/drivers/i2c/busses/i2c-i801.c b/drivers/i2c/busses/i2c-i801.c index e32ef3f01fe8..ebb4c0b03057 100644 --- a/drivers/i2c/busses/i2c-i801.c +++ b/drivers/i2c/busses/i2c-i801.c @@ -1709,6 +1709,16 @@ static inline int i801_acpi_probe(struct i801_priv *priv) { return 0; } static inline void i801_acpi_remove(struct i801_priv *priv) { } #endif +static unsigned char i801_setup_hstcfg(struct i801_priv *priv) +{ + unsigned char hstcfg = priv->original_hstcfg; + + hstcfg &= ~SMBHSTCFG_I2C_EN; /* SMBus timing */ + hstcfg |= SMBHSTCFG_HST_EN; + pci_write_config_byte(priv->pci_dev, SMBHSTCFG, hstcfg); + return hstcfg; +} + static int i801_probe(struct pci_dev *dev, const struct pci_device_id *id) { unsigned char temp; @@ -1830,14 +1840,10 @@ static int i801_probe(struct pci_dev *dev, const struct pci_device_id *id) return err; } - pci_read_config_byte(priv->pci_dev, SMBHSTCFG, &temp); - priv->original_hstcfg = temp; - temp &= ~SMBHSTCFG_I2C_EN; /* SMBus timing */ - if (!(temp & SMBHSTCFG_HST_EN)) { + pci_read_config_byte(priv->pci_dev, SMBHSTCFG, &priv->original_hstcfg); + temp = i801_setup_hstcfg(priv); + if (!(priv->original_hstcfg & SMBHSTCFG_HST_EN)) dev_info(&dev->dev, "Enabling SMBus device\n"); - temp |= SMBHSTCFG_HST_EN; - } - pci_write_config_byte(priv->pci_dev, SMBHSTCFG, temp); if (temp & SMBHSTCFG_SMB_SMI_EN) { dev_dbg(&dev->dev, "SMBus using interrupt SMI#\n"); @@ -1952,10 +1958,9 @@ static void i801_shutdown(struct pci_dev *dev) #ifdef CONFIG_PM_SLEEP static int i801_suspend(struct device *dev) { - struct pci_dev *pci_dev = to_pci_dev(dev); - struct i801_priv *priv = pci_get_drvdata(pci_dev); + struct i801_priv *priv = dev_get_drvdata(dev); - pci_write_config_byte(pci_dev, SMBHSTCFG, priv->original_hstcfg); + pci_write_config_byte(priv->pci_dev, SMBHSTCFG, priv->original_hstcfg); return 0; } @@ -1963,6 +1968,7 @@ static int i801_resume(struct device *dev) { struct i801_priv *priv = dev_get_drvdata(dev); + i801_setup_hstcfg(priv); i801_enable_host_notify(&priv->adapter); return 0; diff --git a/drivers/i2c/busses/i2c-mt65xx.c b/drivers/i2c/busses/i2c-mt65xx.c index efc14041d45b..0cbdfbe605b5 100644 --- a/drivers/i2c/busses/i2c-mt65xx.c +++ b/drivers/i2c/busses/i2c-mt65xx.c @@ -681,8 +681,8 @@ static int mtk_i2c_calculate_speed(struct mtk_i2c *i2c, unsigned int clk_src, unsigned int cnt_mul; int ret = -EINVAL; - if (target_speed > I2C_MAX_FAST_MODE_PLUS_FREQ) - target_speed = I2C_MAX_FAST_MODE_PLUS_FREQ; + if (target_speed > I2C_MAX_HIGH_SPEED_MODE_FREQ) + target_speed = I2C_MAX_HIGH_SPEED_MODE_FREQ; max_step_cnt = mtk_i2c_max_step_cnt(target_speed); base_step_cnt = max_step_cnt; @@ -759,7 +759,7 @@ static int mtk_i2c_set_speed(struct mtk_i2c *i2c, unsigned int parent_clk) for (clk_div = 1; clk_div <= max_clk_div; clk_div++) { clk_src = parent_clk / clk_div; - if (target_speed > I2C_MAX_FAST_MODE_FREQ) { + if (target_speed > I2C_MAX_FAST_MODE_PLUS_FREQ) { /* Set master code speed register */ ret = mtk_i2c_calculate_speed(i2c, clk_src, I2C_MAX_FAST_MODE_FREQ, diff --git a/drivers/i2c/busses/i2c-mxs.c b/drivers/i2c/busses/i2c-mxs.c index 9587347447f0..c4b08a924461 100644 --- a/drivers/i2c/busses/i2c-mxs.c +++ b/drivers/i2c/busses/i2c-mxs.c @@ -25,6 +25,7 @@ #include <linux/of_device.h> #include <linux/dma-mapping.h> #include <linux/dmaengine.h> +#include <linux/dma/mxs-dma.h> #define DRIVER_NAME "mxs-i2c" @@ -200,7 +201,8 @@ static int mxs_i2c_dma_setup_xfer(struct i2c_adapter *adap, dma_map_sg(i2c->dev, &i2c->sg_io[0], 1, DMA_TO_DEVICE); desc = dmaengine_prep_slave_sg(i2c->dmach, &i2c->sg_io[0], 1, DMA_MEM_TO_DEV, - DMA_PREP_INTERRUPT | DMA_CTRL_ACK); + DMA_PREP_INTERRUPT | + MXS_DMA_CTRL_WAIT4END); if (!desc) { dev_err(i2c->dev, "Failed to get DMA data write descriptor.\n"); @@ -228,7 +230,8 @@ static int mxs_i2c_dma_setup_xfer(struct i2c_adapter *adap, dma_map_sg(i2c->dev, &i2c->sg_io[1], 1, DMA_FROM_DEVICE); desc = dmaengine_prep_slave_sg(i2c->dmach, &i2c->sg_io[1], 1, DMA_DEV_TO_MEM, - DMA_PREP_INTERRUPT | DMA_CTRL_ACK); + DMA_PREP_INTERRUPT | + MXS_DMA_CTRL_WAIT4END); if (!desc) { dev_err(i2c->dev, "Failed to get DMA data write descriptor.\n"); @@ -260,7 +263,8 @@ static int mxs_i2c_dma_setup_xfer(struct i2c_adapter *adap, dma_map_sg(i2c->dev, i2c->sg_io, 2, DMA_TO_DEVICE); desc = dmaengine_prep_slave_sg(i2c->dmach, i2c->sg_io, 2, DMA_MEM_TO_DEV, - DMA_PREP_INTERRUPT | DMA_CTRL_ACK); + DMA_PREP_INTERRUPT | + MXS_DMA_CTRL_WAIT4END); if (!desc) { dev_err(i2c->dev, "Failed to get DMA data write descriptor.\n"); diff --git a/drivers/i2c/busses/i2c-npcm7xx.c b/drivers/i2c/busses/i2c-npcm7xx.c index 75f07138a6fa..dfcf04e1967f 100644 --- a/drivers/i2c/busses/i2c-npcm7xx.c +++ b/drivers/i2c/busses/i2c-npcm7xx.c @@ -2093,8 +2093,12 @@ static int npcm_i2c_master_xfer(struct i2c_adapter *adap, struct i2c_msg *msgs, } } - /* Adaptive TimeOut: astimated time in usec + 100% margin */ - timeout_usec = (2 * 10000 / bus->bus_freq) * (2 + nread + nwrite); + /* + * Adaptive TimeOut: estimated time in usec + 100% margin: + * 2: double the timeout for clock stretching case + * 9: bits per transaction (including the ack/nack) + */ + timeout_usec = (2 * 9 * USEC_PER_SEC / bus->bus_freq) * (2 + nread + nwrite); timeout = max(msecs_to_jiffies(35), usecs_to_jiffies(timeout_usec)); if (nwrite >= 32 * 1024 || nread >= 32 * 1024) { dev_err(bus->dev, "i2c%d buffer too big\n", bus->num); |