1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
|
// SPDX-License-Identifier: GPL-2.0-only
/dts-v1/;
#include "dra62x.dtsi"
#include <dt-bindings/interrupt-controller/irq.h>
/ {
model = "DRA62x J5 Eco EVM";
compatible = "ti,dra62x-j5eco-evm", "ti,dra62x", "ti,dm8148", "ti,dm814";
memory@80000000 {
device_type = "memory";
reg = <0x80000000 0x40000000>; /* 1 GB */
};
/* MIC94060YC6 controlled by SD1_POW pin */
vmmcsd_fixed: fixedregulator0 {
compatible = "regulator-fixed";
regulator-name = "vmmcsd_fixed";
regulator-min-microvolt = <3300000>;
regulator-max-microvolt = <3300000>;
};
};
&cpsw_emac0 {
phy-handle = <ðphy0>;
phy-mode = "rgmii";
};
&cpsw_emac1 {
phy-handle = <ðphy1>;
phy-mode = "rgmii";
};
&davinci_mdio {
ethphy0: ethernet-phy@0 {
reg = <0>;
};
ethphy1: ethernet-phy@1 {
reg = <1>;
};
};
&gpmc {
ranges = <0 0 0x04000000 0x01000000>; /* CS0: 16MB for NAND */
nand@0,0 {
compatible = "ti,omap2-nand";
reg = <0 0 4>; /* CS0, offset 0, IO size 4 */
interrupt-parent = <&gpmc>;
interrupts = <0 IRQ_TYPE_NONE>, /* fifoevent */
<1 IRQ_TYPE_NONE>; /* termcount */
linux,mtd-name= "micron,mt29f2g16aadwp";
#address-cells = <1>;
#size-cells = <1>;
ti,nand-ecc-opt = "bch8";
nand-bus-width = <16>;
gpmc,device-width = <2>;
gpmc,sync-clk-ps = <0>;
gpmc,cs-on-ns = <0>;
gpmc,cs-rd-off-ns = <44>;
gpmc,cs-wr-off-ns = <44>;
gpmc,adv-on-ns = <6>;
gpmc,adv-rd-off-ns = <34>;
gpmc,adv-wr-off-ns = <44>;
gpmc,we-on-ns = <0>;
gpmc,we-off-ns = <40>;
gpmc,oe-on-ns = <0>;
gpmc,oe-off-ns = <54>;
gpmc,access-ns = <64>;
gpmc,rd-cycle-ns = <82>;
gpmc,wr-cycle-ns = <82>;
gpmc,bus-turnaround-ns = <0>;
gpmc,cycle2cycle-delay-ns = <0>;
gpmc,clk-activation-ns = <0>;
gpmc,wr-access-ns = <40>;
gpmc,wr-data-mux-bus-ns = <0>;
partition@0 {
label = "X-Loader";
reg = <0 0x80000>;
};
partition@80000 {
label = "U-Boot";
reg = <0x80000 0x1c0000>;
};
partition@1c0000 {
label = "Environment";
reg = <0x240000 0x40000>;
};
partition@280000 {
label = "Kernel";
reg = <0x280000 0x500000>;
};
partition@780000 {
label = "Filesystem";
reg = <0x780000 0xf880000>;
};
};
};
&mmc2 {
pinctrl-names = "default";
pinctrl-0 = <&sd1_pins>;
vmmc-supply = <&vmmcsd_fixed>;
bus-width = <4>;
cd-gpios = <&gpio2 6 GPIO_ACTIVE_LOW>;
};
&pincntl {
sd1_pins: pinmux_sd1_pins {
pinctrl-single,pins = <
DM814X_IOPAD(0x0800, PIN_INPUT | 0x1) /* SD1_CLK */
DM814X_IOPAD(0x0804, PIN_INPUT_PULLUP | 0x1) /* SD1_CMD */
DM814X_IOPAD(0x0808, PIN_INPUT_PULLUP | 0x1) /* SD1_DAT[0] */
DM814X_IOPAD(0x080c, PIN_INPUT_PULLUP | 0x1) /* SD1_DAT[1] */
DM814X_IOPAD(0x0810, PIN_INPUT_PULLUP | 0x1) /* SD1_DAT[2] */
DM814X_IOPAD(0x0814, PIN_INPUT_PULLUP | 0x1) /* SD1_DAT[3] */
DM814X_IOPAD(0x0924, PIN_OUTPUT | 0x40) /* SD1_POW */
DM814X_IOPAD(0x093C, PIN_INPUT_PULLUP | 0x80) /* GP1[6] */
>;
};
usb0_pins: pinmux_usb0_pins {
pinctrl-single,pins = <
DM814X_IOPAD(0x0c34, PIN_OUTPUT | 0x1) /* USB0_DRVVBUS */
>;
};
};
/* USB0_ID pin state: SW10[1] = 0 cable detection, SW10[1] = 1 ID grounded */
&usb0 {
pinctrl-names = "default";
pinctrl-0 = <&usb0_pins>;
dr_mode = "otg";
};
&usb1_phy {
status = "disabled";
};
&usb1 {
status = "disabled";
};
|
